BH4-H7 Angle Bracket Rod Hanger
The BH4-H7 angle bracket is used to secure wire or 1/4″ rod, to mount equipment, conduit, or ductwork below. Its added section allows mounting it with a hole through the top of a beam, rather than the side.
- Description
The BH4-H7 angle bracket is used to secure wire or 1/4" rod, to mount equipment, conduit, or ductwork below. Its added section allows mounting it with a hole through the top of a beam, rather than the side.
Related Products
-
Read MoreQuick ViewCaddy 1-Hole Strap for Conduit
The CPVC One Hole Wrap Around Pipe Strap is designed to support pipe running horizontally on side of a beam, or as a guide to mount CPVC pipe running perpendicular across the top of a beam, or on a vertical run. Model 1070 may be installed onto wood using supplied fastener, or into minimum 20 gauge steel using one 1/4″ x 1 tek screw.
-
Quick ViewElite Clevis Hanger
A clevis hanger consists of one U-shaped clevis and a second V-shaped clevis with a hole in a flattened section at the base of the V, joined together with a bolt. Clevis hangers are used as a pipe attachment providing vertical adjustment for pipes
-
Read MoreQuick View
Concrete Insert Nut
The concrete insert nut is specifically made to fit inside a concrete insert box, which was embedded in the cement ceiling when it was poured. The insert nut allows threaded rod to be suspended, for the mounting of equipment.
-
Read MoreQuick View
Ceiling Flange, Copper
Ceiling flanges are used to secure threaded rod to a ceiling, so that equipment can be attached to the threaded rod. These flanges are designed to either support 3/8″-16 rod, or 1/2″-13 rod. They have a copper finish, and are excellent choice for interior open ceiling situations where their color will complement other equipment.
-
Quick View
Standard Riser Clamps (6400)
Model 6400 Standard Riser Clamps from Elite components are designed for copper tube sizes. They are available in carbon steel with Copper colored Epoxy (PC) and in sizes from 1/2″ thru 4″.Compares with federal specifications A-A-1192A (Type 8) and ANSI/SP-69 and SP-58 (Type 8) -
Quick View
Standard Riser Clamps (6200-6300)
Model 6200-6300 Standard Riser Clamps from Elite components are designed for standard iron pipe. They are available in either galvanized or plain and in sizes from 1/2″ thru 24″.
Compares with federal specifications A-A-1192A (Type 8) and ANSI/SP-69 and SP-58 (Type 8)
-
Quick View
4-Hole Corner Plate
This basic plate connector can be used to secure three pieces of strut together, with the ends of two pieces against a third strut between them.
-
Read MoreQuick View
Pipe Clamp
A pipe clamp is an attachment which clamps around the pipe to connect it to the remainder of a pipe hanger assembly. Pipe clamps are recommended for the suspension of cold pipe lines and may or may not be insulated.
-
Quick View
Concrete Insert Box, Ceiling
The concrete insert box is designed to allow attachment of threaded rod in a ceiling, and is installed before the cement is poured into the wooden form. Once the cement hardens, and the form is removed, the knockout plate is removed and a concrete insert nut is placed inside. The threaded rod is then screwed into the nut, providing support for equipment to be mounted to.
-
Quick View
3/8″ Weldless Eye Nut
Weldless steel eye nuts are threaded fasteners with a looped head that is used to secure hooks or other devices used to hang equipment from threaded rod.
