BH4 Angle Bracket Rod Hanger
The BH4 angle bracket is used to secure wire or 1/4″ rod, to mount equipment, conduit, or ductwork below. It can be mounted to the side of a beam.
- Description
The BH4 angle bracket is used to secure wire or rod, to mount equipment, conduit, or ductwork below.
Related Products
-
Quick View2-Hole Offset Z Support
This Z-shaped connector allows the joining of two perpendicular pieces of strut, with the open side of each piece facing the same direction.
-
Quick ViewConcrete Insert Box, Ceiling
The concrete insert box is designed to allow attachment of threaded rod in a ceiling, and is installed before the cement is poured into the wooden form. Once the cement hardens, and the form is removed, the knockout plate is removed and a concrete insert nut is placed inside. The threaded rod is then screwed into the nut, providing support for equipment to be mounted to.
-
Quick View
Elite Clevis Hanger
A clevis hanger consists of one U-shaped clevis and a second V-shaped clevis with a hole in a flattened section at the base of the V, joined together with a bolt. Clevis hangers are used as a pipe attachment providing vertical adjustment for pipes
-
Read MoreQuick View
Ceiling Flange, Copper
Ceiling flanges are used to secure threaded rod to a ceiling, so that equipment can be attached to the threaded rod. These flanges are designed to either support 3/8″-16 rod, or 1/2″-13 rod. They have a copper finish, and are excellent choice for interior open ceiling situations where their color will complement other equipment.
-
Quick View
Pipe Roof Support, Pipe Prop APS-2
The APS-2 from Pipe Prop is the standard in adjustable pipe support systems for industry professionals. The durability and reliability of a Pipe Prop product sets it apart as where homemade pipe systems are unpredictable at best.
The APS-2 serves pipes up to 2.5″ in width or smaller and allows you to determine your own heigh using 3/4” Schedule 40 PVC Electrical Conduit (cut required).
The APS-2 comes with 1 base, 1 saddle, and 1 nylon strap for securing your pipe to the saddle. -
Read MoreQuick View
Caddy Stand-Off Strap, 2-Hole for Conduit
Two-hole stand-off straps are used for mounting CPVC pipe to a wall, ceiling, or other surface. They eliminate the need for wood blocks under the pipe. They position the pipe 1-1/2″ off the surface.
-
Read MoreQuick View
Clevis Pipe Hanger, Galvanized
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. These hangers have been given an electroplated galvanized finish which provides general rust resistance, and are suitable for any interior uses.
-
Quick View
3-Hole Corner Plate
This basic plate connector can be used to secure two pieces of strut together, at a 90° angle.
-
Read MoreQuick View
Concrete Insert Nut
The concrete insert nut is specifically made to fit inside a concrete insert box, which was embedded in the cement ceiling when it was poured. The insert nut allows threaded rod to be suspended, for the mounting of equipment.
-
Quick View
Elite Beam Clamp
Elite Beam Clamps are used as structural attachments to the top or bottom of metal beams, purlins, channel, or angle iron.
