BC442 1/4″ Beam Clamp
The BC442 is a zinc plated steel beam clamp that accepts 1/4 inch threaded rod or threaded bridle rings.
- Description
The BC442 is a zinc plated steel beam clamp that accepts 1/4 inch threaded rod or threaded bridle rings.
Related Products
-
Quick View2-Hole Offset Z Support
This Z-shaped connector allows the joining of two perpendicular pieces of strut, with the open side of each piece facing the same direction.
-
Read MoreQuick ViewClevis Pipe Hanger, Stainless Steel
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. This clevis hanger is made from stainless steel, giving it superb rust resistance. It is suitable for any interior use, as well as exterior use.
-
Read MoreQuick ViewPipe Clamp
A pipe clamp is an attachment which clamps around the pipe to connect it to the remainder of a pipe hanger assembly. Pipe clamps are recommended for the suspension of cold pipe lines and may or may not be insulated.
-
Quick ViewConcrete Insert Box, Ceiling, Galvanized
The concrete insert box is designed to allow attachment of threaded rod in a ceiling, and is installed before the cement is poured into the wooden form. Once the cement hardens, and the form is removed, the knockout plate is removed and a concrete insert nut is placed inside. The threaded rod is then screwed into the nut, providing support for equipment to be mounted to.
This version of this equipment is galvanized, and can be used in interior or exterior placements. -
Quick ViewElite Clevis Hanger
A clevis hanger consists of one U-shaped clevis and a second V-shaped clevis with a hole in a flattened section at the base of the V, joined together with a bolt. Clevis hangers are used as a pipe attachment providing vertical adjustment for pipes
-
Read MoreQuick ViewClevis Pipe Hanger, Galvanized
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. These hangers have been given an electroplated galvanized finish which provides general rust resistance, and are suitable for any interior uses.
-
Quick View3-Hole Corner Plate
This basic plate connector can be used to secure two pieces of strut together, at a 90° angle.
-
Quick View
Concrete Insert Box, Ceiling
The concrete insert box is designed to allow attachment of threaded rod in a ceiling, and is installed before the cement is poured into the wooden form. Once the cement hardens, and the form is removed, the knockout plate is removed and a concrete insert nut is placed inside. The threaded rod is then screwed into the nut, providing support for equipment to be mounted to.
-
Read MoreQuick ViewSteel Eye Socket
Steel eye sockets are designed to attached hanging threaded rod to structures. Connectors, supports, and equipment can then be attached to the threaded rod as usual.
-
Quick View4-Hole Corner Plate
This basic plate connector can be used to secure three pieces of strut together, with the ends of two pieces against a third strut between them.
