BH6-H7 Angle Bracket Rod Hanger
The BH6-H7 angle bracket is used to secure wire or 3/8″ rod, to mount equipment, conduit, or ductwork below. Its added section allows mounting it with a hole through the top of a beam, rather than the side.
- Description
The BH6-H7 angle bracket is used to secure wire or 3/8" rod, to mount equipment, conduit, or ductwork below. Its added section allows mounting it with a hole through the top of a beam, rather than the side.
Related Products
-
Read MoreQuick ViewClevis Pipe Hanger, Galvanized
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. These hangers have been given an electroplated galvanized finish which provides general rust resistance, and are suitable for any interior uses.
-
Read MoreQuick ViewPipe Clamp
A pipe clamp is an attachment which clamps around the pipe to connect it to the remainder of a pipe hanger assembly. Pipe clamps are recommended for the suspension of cold pipe lines and may or may not be insulated.
-
Pipe Roof Support, Pipe Prop APS-2
The APS-2 from Pipe Prop is the standard in adjustable pipe support systems for industry professionals. The durability and reliability of a Pipe Prop product sets it apart as where homemade pipe systems are unpredictable at best.
The APS-2 serves pipes up to 2.5″ in width or smaller and allows you to determine your own heigh using 3/4” Schedule 40 PVC Electrical Conduit (cut required).
The APS-2 comes with 1 base, 1 saddle, and 1 nylon strap for securing your pipe to the saddle. -
Elite Beam Clamp
Elite Beam Clamps are used as structural attachments to the top or bottom of metal beams, purlins, channel, or angle iron.
-
Read MoreQuick ViewCeiling Flange, Plain
Ceiling flanges are used to secure threaded rod to a ceiling, so that equipment can be attached to the threaded rod. These flanges are designed to either support 3/8″-16 rod, or 1/2″-13 rod. They have a natural, plain finish, and are excellent choice for interior use.
-
2-Hole Offset Z Support
This Z-shaped connector allows the joining of two perpendicular pieces of strut, with the open side of each piece facing the same direction.
-
Read MoreQuick ViewClevis Pipe Hanger, Stainless Steel
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. This clevis hanger is made from stainless steel, giving it superb rust resistance. It is suitable for any interior use, as well as exterior use.
-
Read MoreQuick ViewCeiling Flange, Copper
Ceiling flanges are used to secure threaded rod to a ceiling, so that equipment can be attached to the threaded rod. These flanges are designed to either support 3/8″-16 rod, or 1/2″-13 rod. They have a copper finish, and are excellent choice for interior open ceiling situations where their color will complement other equipment.
-
Concrete Insert Box, Ceiling
The concrete insert box is designed to allow attachment of threaded rod in a ceiling, and is installed before the cement is poured into the wooden form. Once the cement hardens, and the form is removed, the knockout plate is removed and a concrete insert nut is placed inside. The threaded rod is then screwed into the nut, providing support for equipment to be mounted to.
-
Read MoreQuick ViewConcrete Insert Nut
The concrete insert nut is specifically made to fit inside a concrete insert box, which was embedded in the cement ceiling when it was poured. The insert nut allows threaded rod to be suspended, for the mounting of equipment.






