2-Hole Offset Z Support
This Z-shaped connector allows the joining of two perpendicular pieces of strut, with the open side of each piece facing the same direction.
- Description
This Z-shaped connector allows the joining of two perpendicular pieces of strut, with the open side of each piece facing the same direction.
Related Products
-
Pipe Roof Support, Pipe Prop APS-2
The APS-2 from Pipe Prop is the standard in adjustable pipe support systems for industry professionals. The durability and reliability of a Pipe Prop product sets it apart as where homemade pipe systems are unpredictable at best.
The APS-2 serves pipes up to 2.5″ in width or smaller and allows you to determine your own heigh using 3/4” Schedule 40 PVC Electrical Conduit (cut required).
The APS-2 comes with 1 base, 1 saddle, and 1 nylon strap for securing your pipe to the saddle. -
Read MoreQuick ViewConcrete Insert Nut
The concrete insert nut is specifically made to fit inside a concrete insert box, which was embedded in the cement ceiling when it was poured. The insert nut allows threaded rod to be suspended, for the mounting of equipment.
-
Read MoreQuick ViewCaddy 1-Hole Strap for Conduit
The CPVC One Hole Wrap Around Pipe Strap is designed to support pipe running horizontally on side of a beam, or as a guide to mount CPVC pipe running perpendicular across the top of a beam, or on a vertical run. Model 1070 may be installed onto wood using supplied fastener, or into minimum 20 gauge steel using one 1/4″ x 1 tek screw.
-
Read MoreQuick ViewClevis Pipe Hanger, Stainless Steel
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. This clevis hanger is made from stainless steel, giving it superb rust resistance. It is suitable for any interior use, as well as exterior use.
-
Read MoreQuick ViewClevis Pipe Hanger, PVC Coated Copper
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. A PVC coating prevents electrolysis between the pipe and the hanger, and it reduces transmitted noise and vibration.
-
3-Hole Corner Plate
This basic plate connector can be used to secure two pieces of strut together, at a 90° angle.
-
Concrete Insert Box, Ceiling, Galvanized
The concrete insert box is designed to allow attachment of threaded rod in a ceiling, and is installed before the cement is poured into the wooden form. Once the cement hardens, and the form is removed, the knockout plate is removed and a concrete insert nut is placed inside. The threaded rod is then screwed into the nut, providing support for equipment to be mounted to.
This version of this equipment is galvanized, and can be used in interior or exterior placements. -
4-Hole Open Angle Connector
This connector is used for connecting two piece of strut, at an open 45° angle, also called 135° angle.
-
4-Hole Corner Plate
This basic plate connector can be used to secure three pieces of strut together, with the ends of two pieces against a third strut between them.
-
Read MoreQuick ViewClevis Pipe Hanger, Galvanized
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. These hangers have been given an electroplated galvanized finish which provides general rust resistance, and are suitable for any interior uses.





