BH4-H7 Angle Bracket Rod Hanger
The BH4-H7 angle bracket is used to secure wire or 1/4″ rod, to mount equipment, conduit, or ductwork below. Its added section allows mounting it with a hole through the top of a beam, rather than the side.
- Description
The BH4-H7 angle bracket is used to secure wire or 1/4" rod, to mount equipment, conduit, or ductwork below. Its added section allows mounting it with a hole through the top of a beam, rather than the side.
Related Products
-
Read MoreQuick View
Steel Eye Socket
Steel eye sockets are designed to attached hanging threaded rod to structures. Connectors, supports, and equipment can then be attached to the threaded rod as usual.
-
Read MoreQuick View
Clevis Pipe Hanger, Galvanized
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. These hangers have been given an electroplated galvanized finish which provides general rust resistance, and are suitable for any interior uses.
-
Read MoreQuick View
Caddy 1-Hole Strap for Conduit
The CPVC One Hole Wrap Around Pipe Strap is designed to support pipe running horizontally on side of a beam, or as a guide to mount CPVC pipe running perpendicular across the top of a beam, or on a vertical run. Model 1070 may be installed onto wood using supplied fastener, or into minimum 20 gauge steel using one 1/4″ x 1 tek screw.
-
Standard Riser Clamps (6200-6300)
Model 6200-6300 Standard Riser Clamps from Elite components are designed for standard iron pipe. They are available in either galvanized or plain and in sizes from 1/2″ thru 24″.
Compares with federal specifications A-A-1192A (Type 8) and ANSI/SP-69 and SP-58 (Type 8)
-
Read MoreQuick View
Concrete Insert Nut
The concrete insert nut is specifically made to fit inside a concrete insert box, which was embedded in the cement ceiling when it was poured. The insert nut allows threaded rod to be suspended, for the mounting of equipment.
-
Read MoreQuick View
Caddy Two-Hole Strap for CPVC Pipe
Caddy 2-Hole Strap helps with the installation of CPVC pipe on wood, masonry or other surface when extra load bearing is needed. Its curved shape positively snaps onto the pipe, making installation easier. For indoor or outdoor applications.
-
Read MoreQuick View
Ceiling Flange, Copper
Ceiling flanges are used to secure threaded rod to a ceiling, so that equipment can be attached to the threaded rod. These flanges are designed to either support 3/8″-16 rod, or 1/2″-13 rod. They have a copper finish, and are excellent choice for interior open ceiling situations where their color will complement other equipment.
-
4-Hole Corner Plate
This basic plate connector can be used to secure three pieces of strut together, with the ends of two pieces against a third strut between them.
-
Read MoreQuick View
Weldless Eye Nut, Stainless Steel
Stainless steel eye nuts are threaded fasteners with a looped head that is used to secure hooks or other devices used to hang equipment from threaded rod.
Each eye nut is made of stainless steel type 316 – which makes them extremely strong and resistant to corrosion and rusting. They are excellent choices for either interior, open-air but covered, or exterior applications. -
3/8″ Weldless Eye Nut
Weldless steel eye nuts are threaded fasteners with a looped head that is used to secure hooks or other devices used to hang equipment from threaded rod.