Wire Rope Clip 316 Stainless

A wire rope clip, sometimes called a clamp, is used to fix the loose end of the loop back to the wire rope. It consists of a U-shaped bolt, a forged saddle, and two nuts.

Clear
  • Additional information
  • Description
  • Installation

Additional information

Size

1/8″, 3/16″, 1/4″, 5/16″, 3/8″

A wire rope clip, sometimes called a clamp, is used to fix the loose end of the loop back to the wire rope. It consists of a U-shaped bolt, a forged saddle, and two nuts.

The correct way to attach wire rope clips is as follows:

  1. Apply the first clip one base width from the dead end of the wire rope. The base or saddle should bear on the line end of the rope - U-bolt on the short end. Tighten nuts firmly.
  2. Attach second clip as close to ends of thimble inside the loop as possible. Tighten nuts but not firmly.
  3. Attach balance of clips spaced equally between first two clips. Tighten all nuts completely.
  4. Apply initial load - inspect nuts and re-tighten. Inspect all clips periodically.