BH-1-2-R Right Angle Strap Hanger
The BH-1-2-R right angle strap hanger is made to fit a beam flange from 1/16″ to 1/8″ thick. It is used to hang straps up to 1-1/2″ wide, to support equipment, conduit, or ductwork.
- Description
The BH-1-2-R right angle strap hanger is made to fit a beam flange from 1/16" to 1/8" thick. It is used to hang straps up to 1-1/2" wide, to support equipment, conduit, or ductwork.
Related Products
-
Quick ViewConcrete Insert Box, Ceiling
The concrete insert box is designed to allow attachment of threaded rod in a ceiling, and is installed before the cement is poured into the wooden form. Once the cement hardens, and the form is removed, the knockout plate is removed and a concrete insert nut is placed inside. The threaded rod is then screwed into the nut, providing support for equipment to be mounted to.
-
Read MoreQuick ViewSteel Eye Socket
Steel eye sockets are designed to attached hanging threaded rod to structures. Connectors, supports, and equipment can then be attached to the threaded rod as usual.
-
Quick View
4-Hole Corner Plate
This basic plate connector can be used to secure three pieces of strut together, with the ends of two pieces against a third strut between them.
-
Quick View
2-Hole Offset Z Support
This Z-shaped connector allows the joining of two perpendicular pieces of strut, with the open side of each piece facing the same direction.
-
Read MoreQuick View
Clevis Pipe Hanger, HDG
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. This clevis hanger has been treated with a hot-dipped galvanized coating, giving it a great rust resistance. It is suitable for any interior use, as well as exterior use.
-
Read MoreQuick View
Concrete Insert Nut
The concrete insert nut is specifically made to fit inside a concrete insert box, which was embedded in the cement ceiling when it was poured. The insert nut allows threaded rod to be suspended, for the mounting of equipment.
-
Read MoreQuick View
Caddy Stand-Off Strap, 2-Hole for Conduit
Two-hole stand-off straps are used for mounting CPVC pipe to a wall, ceiling, or other surface. They eliminate the need for wood blocks under the pipe. They position the pipe 1-1/2″ off the surface.
-
Read MoreQuick View
Clevis Pipe Hanger, Galvanized
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. These hangers have been given an electroplated galvanized finish which provides general rust resistance, and are suitable for any interior uses.
-
Read MoreQuick View
Caddy Two-Hole Strap for CPVC Pipe
Caddy 2-Hole Strap helps with the installation of CPVC pipe on wood, masonry or other surface when extra load bearing is needed. Its curved shape positively snaps onto the pipe, making installation easier. For indoor or outdoor applications.
-
Read MoreQuick View
Clevis Pipe Hanger, Stainless Steel
A clevis hanger is a pipe attachment providing vertical adjustment, consisting of a clevis type top bolted to a formed steel bottom strap. They are recommended for the suspension of non-insulated, stationary pipe lines. This clevis hanger is made from stainless steel, giving it superb rust resistance. It is suitable for any interior use, as well as exterior use.
