BH-2-4-R Right Angle Strap Hanger
The BH-2-4-R right angle strap hanger is made to fit a beam flange from 1/8″ to 1/4″ thick. It is used to hang straps up to 1-1/2″ wide, to support equipment, conduit, or ductwork.
- Description
The BH-2-4-R right angle strap hanger is made to fit a beam flange from 1/8" to 1/4" thick. It is used to hang straps up to 1-1/2" wide, to support equipment, conduit, or ductwork.
Related Products
-
Read MoreQuick View
Concrete Insert Nut
The concrete insert nut is specifically made to fit inside a concrete insert box, which was embedded in the cement ceiling when it was poured. The insert nut allows threaded rod to be suspended, for the mounting of equipment.
-
Concrete Insert Box, Ceiling, Galvanized
The concrete insert box is designed to allow attachment of threaded rod in a ceiling, and is installed before the cement is poured into the wooden form. Once the cement hardens, and the form is removed, the knockout plate is removed and a concrete insert nut is placed inside. The threaded rod is then screwed into the nut, providing support for equipment to be mounted to.
This version of this equipment is galvanized, and can be used in interior or exterior placements. -
3/8″ Weldless Eye Nut
Weldless steel eye nuts are threaded fasteners with a looped head that is used to secure hooks or other devices used to hang equipment from threaded rod.
-
Read MoreQuick View
Steel Eye Socket
Steel eye sockets are designed to attached hanging threaded rod to structures. Connectors, supports, and equipment can then be attached to the threaded rod as usual.
-
Read MoreQuick View
Pipe Clamp
A pipe clamp is an attachment which clamps around the pipe to connect it to the remainder of a pipe hanger assembly. Pipe clamps are recommended for the suspension of cold pipe lines and may or may not be insulated.
-
Elite Beam Clamp
Elite Beam Clamps are used as structural attachments to the top or bottom of metal beams, purlins, channel, or angle iron.
-
Read MoreQuick View
Caddy 1-Hole Strap for Conduit
The CPVC One Hole Wrap Around Pipe Strap is designed to support pipe running horizontally on side of a beam, or as a guide to mount CPVC pipe running perpendicular across the top of a beam, or on a vertical run. Model 1070 may be installed onto wood using supplied fastener, or into minimum 20 gauge steel using one 1/4″ x 1 tek screw.
-
Read MoreQuick View
Caddy Stand-Off Strap, 2-Hole for Conduit
Two-hole stand-off straps are used for mounting CPVC pipe to a wall, ceiling, or other surface. They eliminate the need for wood blocks under the pipe. They position the pipe 1-1/2″ off the surface.
-
3-Hole Corner Plate
This basic plate connector can be used to secure two pieces of strut together, at a 90° angle.
-
Standard Riser Clamps (6400)
Model 6400 Standard Riser Clamps from Elite components are designed for copper tube sizes. They are available in carbon steel with Copper colored Epoxy (PC) and in sizes from 1/2″ thru 4″.Compares with federal specifications A-A-1192A (Type 8) and ANSI/SP-69 and SP-58 (Type 8)