Vega Right Angle Impact Driver Adapter

The new Right Angle Adapter from Vega is rated for Impact Driver and Drill Driver use. It is made from S2 steel, and features industrial grade gears for lasting professional performance. Its low profile makes it easier to work in tight spaces.

• Rated for impact driver and drill driver use
• Low profile, right angle design makes it easier to wwork in tight spaces
• S2 steel hex shank and industrial grade gears for lasting professional performance
• Quick release locking collar securely holds bits in place
• Handle locks into 3 positions, allowing for greater flexibility and control during use

SELECTING THE PROPER HARDNESS LEVEL FOR BITS:
Choosing the proper hardness level for fastener driving tools is important to achieve long tool life. Different applications, operators and power tools require different hardness levels. Vega offers a choice of two hardness levels in many of our bits, Standard and Extra Hard (X). Extra Hard bits are designated by adding an ‘X’ onto the end of the part number.

The proper hardness level depends on the failure mode. If the bit breaks or shatters, select a bit with less hardness. If the failure mode is wear, select a harder bit. In general, high torque applications require lower hardness levels to withstand twisting and resist breakage. Extra Hard bits are mainly used in low torque applications, particularly with hardened screws.

The standard hardness level should be selected unless a specific application suggests using an increased hardness level. Contact your Vega representative for specific recommendations.

MATERIAL & FINISH KNOWLEDGE:
S2 Modified Steel – All Vega bits are made from shock resistant S2 modified steel and have a Rockwell hardness of between 58-62 HRC. S2 Modified steel is the most durable material for the performance required by our professional end users.

Stainless Steel – Ideal for environments where corrosion and rust are severe. The 420C high performance Stainless Steel used by Vega provides a superior mix of strength and corrosion resistance.

Diamond Tip – The diamond grit is embedded in the steel substrate and improves screw engagement reducing the risk of damage to the screw recess. This extra hard diamond coating wears less and grips better than a Titanium coating.

Titanium Nitride – These bits have a rough surface creating millions of micro gripping points. The Titanium coating provides an extra hard surface over the gripping points to protect them during use. The increase in roughness grips the entire recess of the screw and reduces cam out.